Cartek Power Distribution Panel

The next generation of Power Distribution

Cartek Motorsport Electronics are pleased to announce the new Power Distribution Panel. This product is a full redesign of their successful but bespoke, Power Control Panels, with the main aim of allowing the user to customise and configure it themselves.

The CARTEK Power Distribution Panel is an all-in-one solid state solution to power distribution in your race car. Designed to replace all the Fuses, Relays and Switches - this unit greatly simplifies the wiring, saving weight and maximising reliability.

The CARTEK Power Distribution Panel is a 16 Channel PDM and Switch panel in one, The main advantage of using a Power Distribution Panel is that it directly replaces 16 Fuses, Relays, Switches and all the wiring in between.

Features :

● 16 User Configurable Channels (no Laptop required)

● Selectable current settings of 5, 10 or 15 Amps. Combine two channels together for 20, 25 or 30 Amps

● Selectable Functions such as -Momentary action (Starter Motor, Washer Pump etc) -Latching (with memory) -Latching (without memory) -Latching with Time Delay (Heated Screen) -Flashing (Indicators etc) -Toggling (Headlights High Beam/Low Beam) -0v Momentary action (use as ordinary switch for ECU Map etc)

● Over Current and Short Circuit Protection - no Fuses or Relays needed.

● Multi coloured Label Sheet included for full customisation.

● 2 Back light settings as standard.

● 16 Momentary Switch Inputs - allowing any channel to be operated by an additional switch or the Cartek Wireless Control System.

● 16 ECU Inputs - allows the ECU to turn on channels such as Fuel Pumps.

● 4 Dedicated function inputs - Flash Input for Lights, Wash Input for Wipers, Wiper Park position etc

The CARTEK Power Distribution Panel comes with 2 Backlight settings, allowing full illumination of channels in the dark.

Customise your own : Two Sticker sets come with every Power Distribution Panel :

1) Multi-coloured Label Set

2) Black and white Label Set

Both Label sets allow back light illumination.

The Power Distribution Panel has two dedicated pins that can take in the Kill Signal from a CARTEK Battery Isolator XR. This will then shut down the Power Distribution Panel which will stop the engine from running if the ECU is powered by the Power Distribution Panel.

The Power Distribution Panel also has 16 switch inputs and 4 dedicated inputs, meaning you can use our Wireless Control System to activate and control channels.